How to Build the Puck e-Cig Mod Part 7

Okay, nothing left to do on our homemade Puck but the wiring.  Make sure your soldering iron is warmed up and start reading.  Lets make some physical connections before we solder first.

Insert one leg of your resistor into the lug pictured in the photo.  Wrap the other end of the resistor around the LED lead as shown below.

Follow the photos to to the rest of the connections.  Each photo is a connection you need to make.

Okay, congratulations.  You just wried your Puck.  Wasn’t that hard was it?  Now we just need to finish the job and put it all together and test.  We’ll do that in the next “How to Build the Puck e-Cig Battery Mod Part 8“.

Leave a Reply

Your email address will not be published. Required fields are marked *


Unable to load the Are You a Human PlayThru™. Please contact the site owner to report the problem.